If you removed the screws, I suggest using a small piece of masking tape to help you hold the screws while you put them back in place.Īnd do a S.M.A.R.T. Carefully replace and tighten the 3 loose screws. Very carefully, remove the cardstock that you placed between the PCB and the drive head contacts. Cycle power, wait 20 seconds, then begin again. Then you entered the commands too quickly after supplying power to the drive. If you instead see a message similar to this: Wait about 20 seconds, then spin down the motor: If not, you may have the TX & RX wires swapped. Pay attention to upper & lower case - it is important.Īfter a few seconds, Press CTRL+z. NOTE: Commands for you to type are in boldface. Turn on power to the RS232-to-TTL adapter and the hard drive. Proceed at your own risk.Īttach the power supply's SATA power connector to the hard drive. I do not guarantee that they will work for you. I've gathered these instructions from other places and successfully followed them to repair my own drive. You need to read through that entire thread to get good information though - the OP has a few things wrong and is corrected by another poster in later posts. I've read through a few other web pages to gather this information. After reading through them once, you'll probably want to refer to the Short & Simple Instructions for fixing your own drive. These instructions are meant to be fairly comprehensive, with lots of pictures. I'm a pretty frugal guy, and the DIY method didn't sound too intimidating, so I gave it a try and was successful in un-bricking my drive. I was stuck with either paying someone to have it done, or doing it myself. It was under warranty, so Dell sent me a replacement hard drive, but they wouldn't do anything to help with data recovery. If your drive is an OEM drive, then you're probably out of luck. Seagate will fix your drive for free! See this Seagate Forum Post for more information about how to contact Seagate Tech Support to have them fix the issue for you. If your Seagate hard drive was bought at retail, then you are lucky. If your drive is detected, but shows up as a size of 0, then you're drive has a different problem and these instructions will not apply. This can be determined by the fact that it won't be recognized by the computer's BIOS. These are instructions for fixing a Seagate 7200.11 hard drive that is stuck in the BSY state.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |